DOC HOME SITE MAP MAN PAGES GNU INFO SEARCH PRINT BOOK
 
Basic hardware configuration

Using bootstrings

A bootstring is a special command or text string that is entered at the Boot: prompt displayed at system startup. Normally this process is transparent to the operator because when you press <Enter> at the Boot: prompt, the system uses a pre-defined bootstring such as hd(40)unix specified by DEFBOOTSTR in /etc/default/boot.

There are special bootstrings that permit you to define device configurations that override system defaults (without relinking the kernel). For example, you might be using a tape drive at a non-standard address or the system might not be recognizing your host adapter correctly. In a similar way, new device drivers that are not supplied with SCO OpenServer systems can be installed from a floppy disk using the link bootstring.

To define or redefine a device at boot time:

  1. Decide which bootstring you need to use. The most common are listed here:

    Make certain the bootstring parameters you use match your hardware configuration. Additional bootstrings are documented in the boot(HW) manual page.

  2. Turn the machine on and wait for the Boot: prompt. If you are performing an installation, note that this is the only time the Boot: prompt appears; you are not given the opportunity to reboot during the installation .

    Now enter the necessary bootstrings separated by spaces. For example:

    defbootstr Stp=wdha(1,1,0)

defbootstr is not shown in the following examples, but remember that it should be included on the boot line. The system then boots according to the information you provided. If you entered the bootstring incorrectly, an error message is displayed.

For additional information on the boot process and bootstrings, see the boot(HW), boot(F), bootstring(HW), link(HW), and mem(HW) manual pages.


Next topic: Advanced Power Management bootstrings
Previous topic: Configuring devices with bootstrings

© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003